How to Programme a SR60 Roller Door Opener & Handset

Setting the Limits of the SR60 Roller Door Opener

  1. When standing on the inside of the garage looking out note the side of the roller door the unit is mounted on.
  2. If mounted on the right hand side proceed to step 4.
  3. If mounted on the left hand side remove the motor direction jumper①
  4. Place the door in the half open position and re-engage the motor unit.
  5. Press and release the limit button② and the orange LED③ will start flashing.
  6. Press the limit button② to drive the door to the open position, release when at the top.
  7. Press and release the green button④ to save and immediately press and release the purple learn button⑤.
  8. Press the purple learn button⑤ and drive the door to its bottom limit.
  9. Press the green button④ to save.
  10. The door will open to top limit press green button④ to save.
  11. The door will close to bottom limit press green button④ to save.
  12. The orange LED③ will go out.
  13. Proceed to setting the units force.

Setting the Force of the SR60 Roller Door Opener

  1. Door must be in the down position.
  2. Press and release the purple learn button⑤ twice.
  3. The orange LED③ will flash quickly.
  4. Press the green button④ the door will open.
  5. When fully open press the green button④ and the door will close.
    The orange LED③ will go out.
    Force learnt and setup complete.
garage door perth